Question!

What’s a mud knot and what are they for?

 

For most of us, growing and maintaining a beautiful tail is a labor of love.  We want to protect it at all costs, and one way to do that *on a temporary basis* is to do a mud knot.  Mud knots are a braided/knotted/rolled and twisted tail so that the tail can remain high, tight, and clean (out of the mud!). 

 

Think of a polo pony with their typical wrapped up tails - this is what you can duplicate with a mud knot.  I might do a mud knot for a few reasons - a polo match or any short amount of time that the tail needs to be out of the way.  This may be for turnout or if your Veterinarian needs the tail out of the way for a procedure.   

 

Because of how mud knots are done (around the lower part of the tail bone), I really suggest using them cautiously.  I’ll follow up in another article about how you can knot the tail for longer amounts of time with some other ideas that don’t involve the tail bone. 

 

Before you get started, you may be relieved to know that mud knots are easier to do and remain more secure if you start with a slightly dirty tail.  Adding detangler or just after a fresh shampoo/conditioner will leave you pretty frustrated. 

 

Here we go!

-Remove a section of tail from the underside of the tailbone.  It can be pretty thin, and does not need to be as long as the rest of the tail. This will ultimately secure your knot, and will not be put into the braid.  

 5.jpg

-Braid the rest of the tail from the tailbone down - not too loose, not too tight.  Leave about a foot or more at the bottom of the braid unbraided.

 6.jpg

-Instead of having three sections of hair at the end of your braid, combine two of them into one and leave the other one.  (Now you have two sections!)

-Fold the braid and two sections up to the tailbone.  

 8.jpg

-Use your two sections to wrap around the tail in opposite directions.  

 9.jpg

-Join the two sections back up again and start to twist them in a clockwise direction, the twist will eventually double back on itself creating a loop.

 1.jpg

2.jpg

-Grab the piece of hair that you pulled aside at the very beginning.  Use it to wrap around (clockwise again) the twisted loop.  

 3.jpg

-Use both hands and tug your contraption down to tighten it.  You are done!

1.jpg

You can finish it off with a wrap or two of vet wrap, but be very careful about the tailbone.  

Have fun playing with these!


 

blog comments powered by Disqus